Procedure In Nec Esmpro Manager - NEC Express5800 Series Maintenance Manual

Chapter 1 Maintenance
4.1.2

Procedure in NEC ESMPRO Manager

Perform the procedure below to start component.
1. Select General screen of the target component under the ft System tree in Information of server
state/constitution.
2. Check that the current status of the target component is available. The status is shown on Status
Information display of General screen.
3. Select Maintenance screen and click the Execute button of Bring Up operation.
Perform the procedure below to stop the component.
1. Select General screen of the target component under the ft System tree in Information of server
state/constitution.
2. Check that the current status of the target component is available. The status is shown on Status
Information display of General screen.
3. Select Maintenance screen and click the Execute button of Bring Down operation.
Sample screen of NEC ESMPRO Manager

The target component starts after a while.
Tips
 The start result can be verified by "State" in the General screen of target component.
The result of the start operation is reported by the server as an alert.

The target component stops after a while.
Tips

The stop result can be verified by "State" in the General screen of target component.
The result of the stop operation is reported by the server as an alert.
Maintenance screen of CPU Module
Express5800/R320e-E4, R320e-M4 Maintenance Guide (Linux)
4. Maintenance of the Server
25