Slot For The Compactflash Card - Siemens SINAMICS S120 Manual

8.20.11.4

Slot for the CompactFlash card

Slot for the CompactFlash card
Figure 8-29
NOTICE
Only withdraw or insert a CompactFlash card in a no-voltage state
The CompactFlash card may only be removed and inserted when the Control Unit is in a
voltage-free state; doing this during operation instead could result in a loss of data and,
where applicable, a plant standstill.
The CompactFlash card may only be inserted as shown in the photo above (arrow at top
right).
NOTICE
Observe ESD regulations
The CompactFlash card is an electrostatic sensitive component. ESD regulations must be
observed when inserting and removing the card.
Note
Returned item
When returning a defective Control Unit, remove the CompactFlash card and keep it for
insertion in the replacement unit. This is important otherwise the data on the CompactFlash
card (parameters, firmware, licenses, and so on) may be lost.
Cabinet Modules
Manual, 03/2013, A5E03263538A
CompactFlash card slot
8.20 K90, Control Unit CU320-2 DP
Options
437