Equipotential Bonding - Siemens SINAMICS S120 Equipment Manual

8.5.3

Equipotential bonding

The SINAMICS S Booksize drive system is designed for use in cabinets with a PE conductor
connection.
If the drive line-up is arranged on a common unpainted metal-surfaced mounting plate, e.g.
with a galvanized surface, no additional equipotential bonding is needed within the drive line-
up as
• All parts of the switchgear assembly are connected to the protective conductor system.
• The mounting plate is connected with the external PE conductor by means of a finely-
For other installation methods, equipotential bonding must be implemented using conductor
cross-sections as stated in the second item in the list or at least equal to the conductance.
If components are mounted on DIN rails, the data listed in the second item applies for
equipotential bonding. If only smaller connection cross-sections are permissible on
components, the largest must be used (e.g. 6 mm
also apply to distributed components located outside the cabinet.
For a PROFIBUS connection between two cabinets, a finely stranded potential bonding
connector should be used with a cross-section of 4 mm
together with the PROFIBUS cable and connected to the CU320 at the tapped hole provided
using the cable lug.
Equipotential bonding and shielding for PROFIBUS
The cable shield must be connected over a large contact surface area.
Figure 8-7
Equipment Manual for Booksize Power Units
Equipment Manual, (GH2), 03/2006 Edition, 6SL3097-2AC00-0BP3
8.5 Information about electromagnetic compatibility (EMC) and cable routing
stranded copper conductor with a cross-section of 16 mm², including the outer conductor.
From a cross-section of 25 mm² copper, the outer cross-section of the finely-stranded
conductor is halved.
Functional ground connection for PROFIBUS
Cabinet Configuration and EMC Booksize
for TM31 and SMC). These requirements
2
. The conductor must be routed
2
8-21