Options
7.2 DC link supply adapter
7.2.5
Installation
Danger
If a 50 mm wide module or if a DC link component with the appropriate width (e.g. Braking
Module, CSM, VCM) is located at the lefthand end of the drive line-up, then the DC link
bridge including all of the screws must be removed. It is not permissible to insert the screws
without a DC link bridge.
For all other power units and DC link components (e.g. Capacitor Module) that are wider
than 50 mm, it is not permissible to remove the DC link bridge.
If this is not carefully observed, this can result in damage and accidents.
Required tools:
• Flat-bladed screwdriver 1 (0.5 x 3.5)
• Torx screwdriver T10
• Torx screwdriver T20
7-24
Equipment Manual for Booksize Power Units
Equipment Manual, (GH2), 03/2006 Edition, 6SL3097-2AC00-0BP3