Fujitsu 1740 User Manual page 105

9
Attach the stopper wire to the door and adjust the upper and lower hinge
set positions.
Attach the stopper wire to the door and temporarily tighten the M5 hexagon head screw. This
screw will be fully tightened when the wire is attached to the rack.
Adjust the hinge positions. (The upper hinge set component has been left loose since the
door was removed.) Lower the upper hinge set component as far as it will go and then
tighten the retaining screw. Fully tighten the screw while taking care not to tilt the hinge.
Tighten the retaining screws for the upper hinge set component while pressing
down on it in the direction of the lower hinge set component.
Loosen the retaining screws of the lower hinge set component and then lower the component
as far as it will go. The retaining screws of the lower hinge set component will be fully
tightened after the door is mounted on the rack. For now, tighten it only temporarily.
'
Stopper wire
M5 hexagon head screw
Hinge retaining screw
View from the rear of the door
Upper hinge set component
(view from the front of the door)
Full tightening
Lower hinge
set component
(Two locations: upper and lower)
Hinge set
4 Handling the Rack after Installation
E
105