Fujitsu 1740 User Manual page 109

4
Install the removed brackets to the rack.
Install the brackets, which were removed in step 2, on the side horizontally opposite the
standard side.
Secure the hinge assemblies with M5 screws and the rod-receiving brackets with M5 flat
head screws.
Each screw is a self-tapping screw, which requires a certain degree of strength to tighten.
Confirm that the hinge assemblies and rod-receiving brackets are installed correctly as shown
in "Normal state after installation."
'
Hinge assembly
M5 screw
(Two locations:
upper and lower)
(Normal state after installation)
Rod-receiving bracket
M5 flat head screw
(Three locations: upper, center, lower)
(Normal state after installation)
4 Handling the Rack after Installation
E
109