Rack Configuration And Installation; Configuration - Fujitsu 1740 User Manual

3

Rack Configuration and Installation

This section explains the configuration and installation of the 19-inch rack (40U),
its handling procedure, and the rack connection procedure.
3.1

Configuration

This section provides the specifications of the 19-inch rack and its accessories.
3.1.1 Rack with stabilizers
Item
Product name
Type name
Appearance
Unit
mounting
capacity
Size (w) x (d)
x (h) mm
Load capacity
(kg)
Security
Accessories
*1) Ensure that the floor load based on the total rack capacity does not exceed the floor strength
(withstand load) at the installation site (such as an office).
*2) The expansion rack is not equipped with a pair of side covers.
The base rack can be connected to an expansion rack, and the expansion rack can be
connected to another expansion rack. Note, however, that these racks cannot be
connected to Model 1640 and 1624 racks and other series racks.
80
19-inch rack Model 1740 base rack
19R-174A1
Coated black (front and rear doors with punched metal finish)
40U
700 x 1272 (including stabilizers, rack unit: 1050) x 2000)
Total rack capacity: 943 kg (*1)
Total load capacity: 800 kg (excluding rack)
Rack: 143 kg (including stabilizers)
Front and rear doors locked with keys (Key operation is required to lock handle.)
・ Front door, rear door, and a pair of side covers
(attached to the rack before shipment)
・ Rack door keys: 2
・ Stabilizer: 1 (front)
・ Cage nut/screws (washers attached before
shipment): 50 each
・ (If cage nuts/screws are used for mounting
devices at the factory, remaining cage nuts/
screws are supplied.)
・ Cage nut tool
・ Blank panels: 1U x 3, 2U x 5, and 3U x 3 panels
・ Cable holders: 24 (attached to the rack before
shipment)
・ User's guide
Specifications
19-inch rack Model 1740 expansion rack
19R-174B1
Total rack capacity: 910 kg (*1)
Total load capacity: 800 kg (excluding rack)
Rack: 110 kg (including stabilizers)
・ Front door and rear door (attached to the rack
before shipment) (*2)
・ Rack door keys: 2
・ Stabilizer: 1 (front)
・ Connection kit: 1 set
・ Cage nut/screws (washers attached before
shipment): 50 each
・ (If cage nuts/screws are used for mounting
devices at the factory, remaining cage nuts/
screws are supplied.)
・ Cage nut tool
・ Blank panels: 1U x 3, 2U x 5, and 3U x 3 panels
・ Cable holders: 24 (attached to the rack before
shipment)
・ User's guide