Fujitsu 1740 User Manual page 106

10
Mount the door on the rack and attach the stopper wire.
Mount the door on the rack while inserting the pin of the hinge assembly into the hole of the
upper hinge set component. Insert the pin into the upper and lower hinge set components
together. Be careful not to get your fingers caught in the gap between the door and rack.
Slide the lower hinge set component upward to insert the pin of the hinge assembly, and then
tighten the retaining screw to secure it in position. Visually confirm that the gap between the
hinge assembly and upper hinge set component is the same as that between the hinge
assembly and lower hinge set component.
If they are different, adjust the lower hinge set component or hinge assembly mounting
position.
Secure the stopper wire to the frame with an M5 hexagon head screw, and fully tighten the
screw for the door wire that was temporarily tightened.
'
Upper hinge set component
Lower hinge set
component
This completes the procedure for changing the position of the rotation axis of the front door.
106
Tighten the screws to secure the stopper wire while keeping the door open with
the stopper wire stretched.
(Two locations: upper and lower)
M5 hexagon head
Stopper wire
screw
Hinge assembly
Pin of hinge assembly
Confirm the gap