Fujitsu 1740 User Manual page 129

3
Affix rear bracket L to front bracket L, and affix rear bracket R to front
bracket R. Secure them by applying M6 screws to the second screw hole
from the rear on the lower side and the second screw hole from the rear on
the upper side. (See Section G-G.)
M6 screws
Rear bracket R
Rear side position
of table put away
Drawing out the table about 185 mm
Section G-G
Secure the table in position while fully pressing rear brackets L and R against the
rack posts (in the direction of arrow A).
Secure the table in position while fully pressing rear bracket L against front
bracket L and rear bracket R to front bracket R so that no gaps appear (in the
directions of arrows B and C).
If you are unable to press against rear brackets L and R adequately, do so after
slightly loosening the M6 screws marked with an asterisk (*).
The table can be drawn out about 185 mm (until the screw holes for securing rear
brackets L and R are visible). Do not draw it out too much (see section G-G).
When mounting the table on a 19-inch rack other than the SE-RxRCxx, MC-
RxRCxx, and PW-RxRCxx, use screw holes for which the spacing of the M6
screws used to secure rear brackets L and R to front brackets L and R is
maximized.
4
Put away the table that was drawn out in step 2 and engage the simple
retainer mechanism of the slide rails.
M6 screws
Table
Rear bracket R
Front bracket R
Rack post
Front bracket R
Table
Screw holes of rear bracket R
used to secure the table in position
* The same screw hole
positions on rear bracket L
Second screw hole from
the rear on the upper side
Second screw hole from
the rear on the lower side
Rear bracket R
Front bracket R
4 Handling the Rack after Installation
Front bracket L
Rack post
Rear bracket L
129
E