Bvpu Configuration; Bvpu Installation - Toshiba Strara CTX Series Installation And Maintenance Manual

BVPU – Internet Protocol (IP) Interface Unit
Circuits per PCB:
Interfaces with:
Appears as:
Older Version(s):

BVPU Configuration

BVPU controls, indicators, and interface connectors are shown in
Table 4-6.

BVPU Installation

1. Insert the BVPU (component side facing right) into the appropriate slot and apply firm, even
pressure to ensure proper mating of connectors.
2. Attach the 10BaseT Ethernet connection to the LAN connector.
3. Connect a PC equipped with Maintenance Console Software (MCS) to the serial port according to
the drawing below. A serial connection is necessary to establish the IP address of the BVPU. Once
the IP address is established, maintenance may be conducted over the Ethernet port.
4. After installing the BVPU, gently pull it outward. If the connectors are properly mated, a slight
resistance is felt.
BVPU
Figure 4-5 BVPU Monitor Jack
Strata CTX I&M September 2002
four Tie line circuits; one 10BaseT Ethernet connection
H.323 version 2 terminals over an IP network
4 E&M Tie lines
2- or 4-wire transmission
Type I and II Signalling
Immediate and Wink Start
none
Monitor jack
Dealer-supplied
6-wire telephone
modular cord
(cross-pinned)
RD 1
TD 2
DSR 3
DTR 4
DCD 5
SG 6
Call-monitor jack (RJ12)
pin numbering
5243
Figure 4-5 and described in
PC with maintenance
console software
PC DB9 or
DB25 Com port
Toshiba PPTC9 or
PPTC25F
PCB Installation
4-9