Ctx100 License Control; Licensed Software Options - Toshiba Strara CTX Series Installation And Maintenance Manual

Strata CTX Configuration

CTX100 License Control

The system size and feature capability is controlled using a software License Key Code. This key code
is obtained from (http://www.toshiba-telecoms.co.uk/dealer) during the ordering process and is
installed onto the system processor via Strata CTX WinAdmin. Processor license codes activate
system hardware capacities in the following increments.
The first 32 line/station ports do not require a license. Each additional set of four line/station ports
requires one CTX100 PORT LIC license (maximum of 112 ports).
The optional DTMF receiver circuit (ARCS) provides 16 DTMF receiver hardware circuits and 16
ABR circuits. The first four DTMF circuits and all ABR circuits do not require a license. Each
additional set of four DTMF receiver circuits requires one CTX100 DTMF LIC license (maximum
of 16 DTMF circuits).
Note DTMF tone receiver circuits are required for standard telephones, Voice Mail DTMF
integration, Tie, DDI and DNIS line service.
The optional RS-232 serial port interface (BSIS) provides two circuits to interface with SMDI or
Toshiba Proprietary Voice Mail integration, Call Accounting SMDR, and two for future
applications. The first circuit does not require a license, but circuits two through four each require
one CTX100 SERL LIC license.
The list below outlines all the licenses that can be purchased for CTX100 and their associated
capacities.
CTX100 PORT LIC- Purchase of ONE license will increase system ports by 4. Max 112
CTX100 DTMF LIC- Purchase of ONE license will increase DTMF receivers by 4. Max 32
CTX100 CSTA LIC- Purchase of ONE license will increase CSTA sessions by 1. Max 9
CTX100 QSIG LIC- Purchase of ONE license will enable QSig on the switch.
CTX100 WOC LIC- Purchase of ONE license will allow 1 WOC to be supported. Max 4
CTX100 SERL LIC- Purchase of ONE license will allow 1 serial port to be supported. Max 4
but only two have a use at present.

Licensed Software Options

Some software options are activated with license codes. The following software options require a
license:
Each CTX system (node) in a Strata Net QSIG Network requires one CTX100 QSIG LIC license. A
maximum of four serial network nodes are allowed in any one serial chain in the network topology.
The optional AETS PCB provides hardware LAN interface for all CTI Open Architecture
applications. Each individual CTI Open Architecture application requires one CTX100 CSTA LIC
license (maximum nine).
1-4
Strata CTX I&M September 2002