Tilt Stands And Wall Mounting - Toshiba Strara CTX Series Installation And Maintenance Manual

Station Apparatus

Tilt Stands and Wall Mounting

This section explains how to attach desktop tilt stands to 3000/3500-series or 2000/2500-series digital
DKTs or to a DSS console. Use Tilt Stand model "BTSD" (not BTSA) with a standalone DKT or DSS.
To attach a Tilt Stand to a 3000/3500-series DKT or DSS
1. Plug the phone jack into the bottom of the phone or DSS console.
2. Slide the Address Tray out, then gently squeeze the tray and remove it (see
3. Pull the top of the Tilt Stand so that it's open at an angle.
4. Slide the Tilt Stand into the former Address Tray holder. (The Stand should catch under the front
tray holder notches.) Push Stand in until it snaps into place (see
5. Push in the Lock Release to adjust the tilt angle (0, 10, 20 or 30 degrees, see
6. Insert the Address Tray back into its holder.
5448
Figure 7-17 Bottom View of Digital Telephone
Figure 7-19 Tilt Stand "Snaps" In
7-22
Plug in
phone jack
Squeeze and
slide out the
address tray
5847
Figures 7-18
Figure 7-18 Slide Tilt Stand into Address Tray Slot
5848
Notice:
If you change the DKT tilt stand angle, hold the DKT
in your hand when you push the release button so the
unit does not fall onto the stand.
Figure 7-20 Telephone on a Tilt Stand
Figure 7-17).
and 7-19).
Figure 7-20).
5846
Lock Button
Release
Strata CTX I&M September 2002