Digital Add-On Module Installation - Toshiba Strara CTX Series Installation And Maintenance Manual

Station Apparatus
3 Msg
press (
4 Msg
press (
Hold
4. Press to set the option.
5. Go off-hook, then on-hook to exit the program mode.
Note On the DKT3001, the Msg LED shows if the feature has been turned On/Off. There is no
visible indication on the other telephones. If the telephone ringer and busy tone buzzes or
doesn't sound clear, check the country settings.
Table 7-6 Country Code Settings for Mu Law/A Law
USA, Canada (default is Mu Law)
Mexico
Taiwan
Hong Kong, Thailand
Singapore, Malaysia, Indonesia, Sri Lanka, India, China
UK, Ireland
Australia

Digital Add-on Module Installation

The DADM provides 20 buttons that can be flexibly programmed for any telephone feature that is
provided by the Strata CTX system.
Install one or two DADM to a Toshiba digital telephone
(only) (shown below). The digital telephone and the
DADM must belong to the same series, i.e., 3000/3500- or
2000/2500-series
See the appropriate system Installation Chapter for
loop length and secondary protection requirements.
DADMs cannot be installed on telephones that have
BPCI, BVSU or DVSU installed.
Only 1 ADM can be fitted to DKT3500-series.
To install DADMs
See Figure 7-16 and follow these steps:
1. Loosen the four captive screws on the digital
telephone base and remove it.
2. Remove the base handset hanger.
3. Loosen two captive screws on DADM and remove bases.
4. Put the DADM supplied cable through the telephone and DADM bases.
5. Connect DADM cable connectors to P1 of DADM and P1 of DKT telephone.
6. Install base of DADM and telephone – tuck DADM cable into DADM and telephone base, as
necessary, for proper length.
7. Secure DADM to telephone base with DADM connecting plate (using four screws).
7-20
LED Off means that FB3 is Off)
LED Off means that FB4 is Off)
Country FB1 FB2
Off Off
Off Off
On Off
Off On
On On
Off Off
On Off
Strata CTX I&M September 2002
FB3 FB4
Off Off
Off On
Off Off
Off Off
Off On
On On
Off On
5843