Toshiba Strara CTX Series Installation And Maintenance Manual page 59

5. Secure the top two screws approximately two thirds of the way into the top two holes on the back
board.
6. Hang the Base Cabinet back cover from the top two screws and then secure the top and bottom
screws completely into the back board. The base back cover should now be tightly secured to the
back board. See
7. To mount the Base Cabinet, position the cabinet hanger holes onto back cover hangers (two on top
and two on the bottom as shown in
8. Secure the Base Cabinet to the back cover with a screw through the left side bracket of the back
cover to the Base Cabinet. (See Screw "A" in
9. If you are installing an Expansion Cabinet, go to
required)" on Page
Screw A
Flange
Hook
Figure 2-5 Cabinet Wall Mounting
Strata CTX I&M September 2002
Figure 2-5.
Figure
2-8. Follow the steps, then return to these steps.
Flange
Hook
2-6). Slide the cabinet to the left.
Figure 2-5.)
"Step 5: Mount the Expansion Cabinet (if
Stud
Strata CTX100 Installation
Plaster
Board
Back Board
(1/2 Inch
Plywood)
5912
2-7