Toshiba Strara CTX Series Installation And Maintenance Manual page 74

Strata CTX100 Installation
Do Not Run Cables Out the Top – Cabling from either cabinet should be routed out the lower
sides, not from the top of the cabinet(s) (see
Figure 2-21 Avoid Improper Cable Routing
2. Remove the left or right cover(s) of
the cabinet and knock out the
rectangle(s) to create a hole for the
cables, as needed (see
Cables can be run out of either
Note
side of Base or Expansion
cabinets.
3. Connect applicable wiring (e.g.,
modular Exchange line cords, 25-
pair amphenol connector cables) to
the front of the PCBs as described
earlier.
4. Secure all Amphenol cables to the
cabinets with tie wraps (see
2-23).
2-22
P ower S upply
Figure 2-22).
T o avoid heat problems,
do not store items on
top of the c abinets.
R un c ables through c over
knoc k-outs holes
(on all side c overs)
Figure 2-22
Figure
Figure 2-21).
P ower S upply
6008
Base and Expansion Cabinet Cables and
Connectors
Figure 2-23 Tie-wrap Cables
Strata CTX I&M September 2002
5968