6-28
Procedure 6-6
Outlines of parts
Cable jacket
Aluminum tape
Center conductor
Braided wire
Insulator
Tools
1
Insertion of parts
2
Remove of jacket of cable, insertion of parts,
(1) Remove 13 mm of jacket only.
(2) The clamp1 is inserted as shown.
Note
Tools
NWD-107460-02E
Submission Prohibited
NEC Internal Use Only
N-P Connector used for ODU IF IN/OUT
(Straight: N435(R0))
[Applicable cable: 5D-FB-E]
Washer
Clamp nut
•
knife, cutter, nipper, tweezers, file, measure,
clearance gauge, etc.
•
spanner, torque spanner; 16 mm
The clamp nut, the washer and the gasket are inserted in the cable.
Cable
Clamp nut
Do not damage the braided wire.
•
knife
•
cutter
•
measure, etc.
Gasket
Clamp1
Clamp2
Washer
Gasket
13 mm
(Clamp1)
CABLE TERMINATION
Connector body
Installation