6-32
6.2 8D Coaxial Cable
Procedure 6-7
Outlines of parts
Cable jacket
Center conductor
Braided wire
Tools
Cable jacket
In case of cable type A (φA)
1
Insertion of parts and remove of jacket of cable.
(1) The clamp nut, the washer are inserted in the cable.
(2) Remove 9 to 10 mm of jacket only.
Tools
Note
NWD-107460-02E
Submission Prohibited
NEC Internal Use Only
TNC-P Connector used for IDU IF IN/OUT
(L-angle: TNC141(R0))
[Applicable cable: 8D-FB-E]
Aluminum tape
Connector body
Insulator
•
knife, cutter, nipper, tweezers, file, measure,
clearance gauge, etc.
•
spanner, torque spanner 16 mm
Clamp nut
•
knife
•
cutter
•
measure, etc.
Do not damage the braided wire.
Spacer
Contact
cord tube
Diameter over cable jacket
φA or φB
φA: 11 mm
φB: 10 mm
Washer
9-10 mm
CABLE TERMINATION
Washer
Clamp nut
Clamp
Installation