Removing Crimp Contacts - NEC iPasolink 200 Manual

6-52
7 Take out the crimped contacts from the chamber. Check if it should not be
scratched or transformed,
8 After crimping the stranded wire to the contact using a hand tool, insert the
contact into the contact chamber with the tool, working from the wiring side,
9 You can here the contacts snap home, audible "click",
10 Check if they are securely in place with giving the wire a gentle pull.

Removing crimp contacts

1 Position the tool from the wiring side as shown left and insert into the contact
chamber. The contact can then easily be removed from the wiring side together
with itself and reinserted in a different chamber.
Contact chamber
[Insertion]
Contact can be inserted
together with wire.
Note
Note
NWD-107460-02E
Submission Prohibited
NEC Internal Use Only
Insertion and removal tool
Wire
[Removal]
Contact can be removed
together with wire.
Connector
Use D-sub connectors of less than 16 mm in height as illustrated below.
Use D-sub 44-pin connector for the CTRL of less than 57 mm in width as
illustrated below.
Insertion and removal tool
Position the
Insertion and removal tool
D-sub connector
Height
D-sub 44 pin connector for the CTRL
Width
CABLE TERMINATION
(09 99 000 0513)
Installation