Cable Termination; List Of Applicable Cable - NEC iPasolink 200 Manual

CABLE TERMINATION

In this section, list of tools, materials and the method for cable termination are
described. The list of applicable cable is shown in Table 6-1.
Applicable Cable
5D Coaxial for IDU
Cable
for IDU
for IDU
for ODU
for ODU
for ODU
8D Coaxial for IDU
Cable
for ODU
for ODU
Other Cables for power supply
for 120 ohms
balanced signal
for auxiliary signal
Notes
Installation
Submission Prohibited
NEC Internal Use Only
6. CABLE TERMINATION
Table 6-1 List of Applicable Cable
Connector Type
TNC-P L-angle
TNC-P L-angle
TNC-P L-angle
N-P L-angle
N-P Straight
N-P Straight
TNC-P L-angle
N-P L-angle
N-P Straight
AMP Housing &
socket contacts
D-sub Crimping
D-sub High Density
1 In 1+1 system, the difference between the No.1 channel IF cable length
and the No.2 channel IF cable length should be within 100 m.
(differential absolute delay time: within 500 ns)
2 When the N (Male) straight connector is attached to the IF cable, use of
the TNC (Male) - N (Female) (NJ-TNCP-LA) L-angle adapter is needed
to connect to the IDU.
3 Use shielded cables which are connected to the D-Sub/RJ-45 connector
to suppress interference from affecting the signal and to reduce
electromagnetic radiation which may interfere with other signal cables.
Model# Procedure#
TNC150(R0) Procedure 6-1
300PTR-C-NC Procedure 6-2
TNC156(R0) Procedure 6-3
300PNR-C-NC Procedure 6-4
300PNM-C-NC Procedure 6-5
N435(R0) Procedure 6-6
TNC141(R0) Procedure 6-7
N-LP-8DFB(B) Procedure 6-8
N416(R0) Procedure 6-9
AMP: 1-178288-4 or Procedure 6-10
DK-3100S-04R
--- Procedure 6-11
--- Procedure 6-12
NWD-107460-02E
6-1