Fccs Call Termination Test; Attcon Connection Test (Via Fccs); Figure 6-8 Station-To-Station Connection Test (Origination) Via Fccs - NEC NEAX 2400 IPX Manual

STEP 3: Dial a telephone number (STN B) that belongs to another node.
STEP 4: The call terminates on STN B.
STEP 5: Confirm the speech condition is sufficient (no noise, not one-way speech, etc.).
STEP 6: Replace the handset of STN A.
STEP 7: Repeat the above steps for all Fusion links.
3.1.2

FCCS Call Termination Test

STEP 1: Using the MBCT command, make busy all trunks in the origination route except the trunk to be tested
at Node B.
STEP 2: Lift the handset of STN B in Node B.
STEP 3: Dial a telephone number (STN A) that belongs to the self-node.
STEP 4: The call terminates on STN A.
STEP 5: Confirm the speech condition is sufficient (no noise, not one-way speech, etc.).
STEP 6: Replace the handset of STN B.
STEP 7: Repeat the above steps for all Fusion links
.
Dial LSTN
"420000"
STN A
LS TN : 410000
STN : 2000
Call Origination
Note: Using the MBCT command, make busy all B-channels in the route except the trunk to be tested.

Figure 6-8 Station-to-Station Connection Test (origination) via FCCS

3.2 ATTCON Connection Test (via FCCS)

Perform the ATTCON connection test by following the procedures below and by referring to
N ode A (Self-N ode)
LC
B ch: busy
B ch: idle
B ch: busy
B ch: busy
N ode B
FCCS
NDA-24299
POST INSTALLATION TEST
FCCS Network Connection Test
LC
STN B
LSTN : 420000
S TN: 2000
RG
M BC T C om m an
d
(Make Busy Inform ation)
0: M ake idle
1: M ake Busy
Figure
CHAPTER 6
Revision 1.0
Check
6-9:
Page 151