NEC NEAX 2400 IPX Manual page 184

F LT IN F =03 H is indicate d;
1. xx0x xxxx xxxx xxxx
Note 1
Note 1: Refer to the previous page for this information.
Failure Detail Identification consists of the following:
Note 2:
02=TCP Link Error
Probable causes are:
• KEEP ALIVE packet time out
• CP packet sending failure
• ST packet receiving
• CMP (Information unable to reach the destination) receiving
• CMP (Parameter irregular information) receiving
11=Receiving Packet Error 1 (Sending/Receiving of User Information is started; however, Time Out occurs because the
sending/receiving have not completed within the determined time period.
12=Receiving Packet Error 2 (When User Header Information included in receiving packet is searched, but "Not-found"
state continues over the determined time period.
13=Receiving Packet Error 3 (Time out occurs because User data following the User Header Information has not received
completely within the determined time period.
2. xxxx xxxx xxxx xxxx ......
C on nection O perating Typ e
01=C lien t
02=S e rver
K in d of P ort
0 1=P ort fo r F C C S S ig nalin g
0 2=P ort fo r B ch C o ntrolling
Figure 7-11 23-S FCH Failure Notification (Continued)
NDA-24299
23-S FCH Failure Notification (Detection)
F ault D eta il
Id entification
F au lty S id e Inform ation
0 1=N o t de term ined
0 2=S ou rce side
0 3=D e stin ation side
}
2 B ytes
F aulty P o rt N o. (D estination )
}
2 B yte s
F aulty P ort N o. (S ou rce)
}
4 B yte s
IP A d dre ss of th e de stin ation F G H /R o uter
on w hich con nection failu re occurs.
TROUBLESHOOTING
Note 2
CHAPTER 7
Page 169
Revision 1.0