When Seizing A Trunk From An Attcon; Figure 6-13 Ccis-Fccs Outgoing Call Test - NEC NEAX 2400 IPX Manual

POST INSTALLATION TEST
Fusion and Non-Fusion Connection Tests
STEP 2: Station A in self-node (Node A) dials the Physical Station Number for Station B in Node C.
STEP 3: The call terminates to Station B via FCCS and non-FCCS.
STEP 4: Confirm the speech condition is sufficient (no noise, not one-way speech, etc.).
STEP 5: Replace the handset of STN A.
STEP 6: Repeat the above steps for all Fusion links.

4.2 When Seizing a Trunk from an ATTCON

STEP 1: The operator at the ATTCON in self-node (Node A) dials Physical Station Number for Station B in
Node C.
STEP 2: The call terminates to Station B via FCCS and non-FCCS.
STEP 3: Confirm the speech condition is sufficient (no noise, not one-way speech, etc.)
STEP 4: The operator at the ATTCON releases the call by pressing the CANCEL key.
N ode A (S elf-N ode)
LC
S T N A
T E LN : 410000
S T N : 2000
A TI
A TT C O N
CHAPTER 6
Page 156
Revision 1.0
N ode B
F C C S

Figure 6-13 CCIS-FCCS Outgoing Call Test

NDA-24299
N ode C
N on-F C C S
Check
LC
S T N B
T E LN : 420000
S T N : 2000