Flexible Routing - Fusion; Network Data Programming For Tandem Connection Via "Fccs" - "Ccis - NEC NEAX 2400 IPX Manual

DATA PROGRAMMING
Assignment of FCH Related Data
STEP 9: ACAN
Assign the CIC number to the connection trunk.
FPC: 1
STEP 10: AFCD
Assign NAILED DOWN CONNECTION for the connection link established between FCCH and
SDT.
LENS-A: LEN of SDT
LENS-B: LEN of FCCH

7.3 Flexible Routing - Fusion

A Fusion trunk call can be routed via "non-Fusion" trunk (C.O. or Tie Line), if the Fusion trunks are all
busy or Data Link Failure occurs at the FCH card, etc.
Service Conditions
a. This feature may be activated when the Fusion trunks are all busy or FCCS Link Failure (Layer 2
down) occurs at the FCH card.
b. This feature is available when the called party is an analog station, Dterm or ISDN terminal. (When
the called party is wireless terminal or DAT/Paging Trunk, the feature is not activated.)
c. Use LCR/LCRS for this feature.
d. The access code of this feature (ACC: max. 24 digits) is assigned by the AFRFL command.
e. When the selected "non-Fusion" trunks (LCR/LCRS) are also busy, route selection is performed
according to the LCR/LCRS table. The same is performed when the selection encounters a Fusion
trunk "busy" again.
STEP 1: Basic Data
Make sure that the following data has been already assigned for the Fusion network.
Flexible Route Numbering Plan Data (LCR/LCRS data)
Station-to-Station connection data
STEP 2: AFRFL
Assign Flexible Route data (tenant number, destination node FPC and feature access code) by the
AFRFL command.
TN:
FPC:
ACC: Access Code for Flexible Routing (to C.O. or Tie Line), the same number assigned by ASPA
command for LCR/LCRS.

7.4 Network Data Programming for Tandem Connection via "FCCS" - "CCIS"

To establish CCIS services between FPC1 (PC1) and PC3 via FCCS - CCIS link, it is required to perform
the following data assignment at FPC1 (PC1) node as explained.
CHAPTER 5
Page 100
Revision 1.0
FCIC: 1-664 CLENS: LEN of the connection trunk
EAD-A: 07 (pad off)
EAD-B: 07 (pad off)
Tenant Number of the Calling Party.
Fusion Point Code of the destination node.
NDA-24299