Figure 5-40 Example Of Ogca - NEC NEAX 2400 IPX Manual

... ... .. .
... ... .. .
... ... .. .
... ... .. .
STN (C)
Station C dials
9-1-303-456-7890
STEP 1: ANPDN/ANPDL
Assign the first digit of the OGCA access code. When the access code is common to all nodes, use
the ANPDN command. When the access code is assigned for each node, use the ANPDL command.
1st DC=9
1st DC=9
STEP 2: ASPAN/ASPAL
Assign the OGCA access code. When the access code is common to all nodes, use the ASPAN
command. When the access code is assigned for each node, use the ASPAL command.
ACC=9 CI=N (Normal)
ACC=9 CI=H (Hooking)
Note: When entering the data in STEP 1 and STEP 2, do not mix the commands for LDM and NDM. Write the
data on the same data memory as shown below:
• When writing the data on the LDM:
• When writing the data on the NDM:
Node C
FCCS
... .. .
... .. .
... .. .
... .. .

Figure 5-40 Example of OGCA

Note
CI=N (Normal) NND=1
CI=H (Hooking)NND=1
Note
SRV=OGCACOUNT=21st LGRT=1002nd LGRT=200
SRV=OGCACOUNT=21st LGRT=1002nd LGRT=200
Node B
BUSY
COT
LGRT:100
FCCS
LGRT:200
COT
1-303-456-7890
Node A
ANPDL (STEP 1) → ASPAL (STEP 2)
ANPDN (STEP 1) → ASPAN (STEP 2)
NDA-24299
DATA PROGRAMMING
Assignment of FCH Related Data
PSTN
CHAPTER 5
Revision 1.0
Page 93