NEC NEAX 2400 IPX Manual page 110

STEP 1: ANPDN/ANPDL
Assign the first digit of the LCR/LCRS access code. When the access code is common to all nodes,
use the ANPDN command. When the access code is assigned for each node, use the ANPDL
command.
TN=1
TN=1
STEP 2: ASPAN/ASPAL
Assign the LCR/LCRS access code for a dummy route number. When the access code is common to
all nodes, use the ASPAN command. When the access code is assigned for each node, use the ASPAL
command.
ACC=8
ACC=8
STEP 3: AMND
Using AMND, assign the Maximum Necessary Digits to be received by Register (ORT) circuit.
DC=8110
STEP 4: ARNPL
Using ARNPL, assign the access code for each external trunk route but not for a dummy route.
RT=10
RT=200
When entering the data in STEP 1, 2, 6, 7, and 8, do not mix the commands for LDM and NDM. Write the
Note:
data on the same data memory as shown below:
• When writing the data on the LDM:
ANPDL →
(STEP 1)(STEP 2)
• When writing the data on the NDM:
ANPDN →
(STEP 1)(STEP 2)
Note
1st DC=8 CI=N (Normal)NND=1
1st DC=8 CI=H (Hooking)NND=1
Note
CI=N (Normal) SRV=LCR/LCRSLGRT=Dummy route number
CI=H (Hooking) SRV=LCR/LCRSLGRT=Dummy route number
MND=8
ACC=8
ACC=9
ASPAL→ AFRSL→AOPRL→AADCL
(STEP 6)
ASPAN→ AFRSN→AOPRN→AADCN
(STEP 6)
(STEP 7)(STEP8)
(STEP 7)(STEP8)
NDA-24299
DATA PROGRAMMING
Assignment of FCH Related Data
CHAPTER 5
Revision 1.0
Page 95