NEC NEAX 2400 IPX Manual page 111

DATA PROGRAMMING
Assignment of FCH Related Data
STEP 5: ARTD/ARTDN
Using ARTD, assign the following CDN data for the dummy route number.
CDN 6 (TCL)=1 or 4 (depending on requirement)
CDN 7 (L/T)=1
CDN 13 (AC)=1
The other CDNs may be left default (data 0) for the dummy route.
STEP 6: AFRSL/AFRSN
Using AFRSL, assign the Number Pattern Code (NPC) and the Outgoing Route Selection Pattern
Number (OPR) for the dummy route number.
LGRT=Dummy route numberNPC=8110OPR=1
STEP 7: AOPRL/AOPRN
Using AOPRL, assign the external route number to OPR assigned in the AFRSL command.
TDPTN=0
PRSC=0
TDPTN=0
PRSC=0
STEP 8: AADCL/AADCN
Using AADCL, assign the additional Digit Code to PNL assigned in the AOPRL command.
PNL=128
DC=12025678901
STEP 9: ARSCN
Using ARSCN, assign the Route Restriction Class (RSC) that allows RRIs for the external trunk
route. The same route restriction data must be assigned for each node.
Note 1: The dummy route must be assigned to all nodes (including a node that does not have external routes).
Note 2: When entering the data in STEP 1, 2, 6, 7, and 8, do not mix the commands for LDM and NDM. Write the
data on the same data memory as shown below:
• When writing the data on the LDM:
ANPDL →
(STEP 1)(STEP 2)
• When writing the data on the NDM:
ANPDN →
(STEP 1)(STEP 2)
CHAPTER 5
Page 96
Revision 1.0
Note 2
Note 2
OPR=1 RA=0E=1LGRT=10SKIP=4
OPR=1 RA=1E=0LGRT=200SKIP=8
Note 2
ASPAL→ AFRSL→AOPRL→AADCL
(STEP 6) (STEP 7)(STEP8)
ASPAN→ AFRSN→AOPRN→AADCN
(STEP 6) (STEP 7)(STEP8)
NDA-24299
Note 1
PNL=0 OVFT=0
PNL=128 OVFT=0