Figure 5-32; Figure 5-33 Afpc Command Display (Example) - NEC NEAX 2400 IPX Manual

STEP 3: AFPC
Assign routing data for Fusion link using the AFPC command. A maximum of 8 connection_routes
and FCHN/FPCN can be assigned on a node basis. The list box labeled FCCH on the AFPC command
determines the network configuration type between self-node and the intermediate node. Assign "0"
for "Fusion System without FCH" and "1" for "Fusion System with FCH." In case FCCH=1, enter
FCCH number for intermediate node to FCHN/FPCN parameter, and in case FCCH=0, enter the FPC
number of the intermediate node to FCHN/FPCN parameter. In this step, the explanation is given
using the following network as an example.
his figure shows an example of Fusion network. Each number in the circle stands for Fusion Point Code (FPC).
NCN: Network Control Node
LN: Local Node
The AFPC command display (Fusion with FCH) should look similar to
"USE_GATE" data is automatically assigned.
Note:
The AFPC command affects communications between nodes, and according to
WARNING:
conditions, it might be unable to communicate between the nodes. Operate the
MAT directly connected to each node as the need to modify the data setting.
Node A
10
NCN
LN
12
LN
Figure 5-32 Fusion Network (example)
AFPC (Assignment of FCCH Routing Data for LDM)
Assign Destination FPC (far end FPC).
FPC
FCCH
22 1
CNT C_RT
FCHN/FPCN
1
10
2
3
4
For Help, press F1

Figure 5-33 AFPC Command Display (example)

Node C
11
LN
1
LN
24
Node F
0: Fusion without FCH / 1: Fusion with FCH
P_ROUTE
Priority Route
0
FCH number (1-255)
CNT C_RT
FCHN/FPCN
5
6
7
8
NDA-24299
DATA PROGRAMMING
Assignment of FCH Related Data
LN
21
LN
22
LN
2
Node B Node D
LN
23
Node E
Figure 5-33:
CHAPTER 5
Revision 1.0
Page 87