Lifting The Entire Vehicle; Using A Booster Battery (Jump Starting) - Husqvarna HUV 4214 2009 Maintenance And Service Manual

3

Using a Booster Battery (Jump Starting)

LIFTING THE ENTIRE VEHICLE

1. Place vehicle on a level surface.
2. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL and set the
park brake. Chock the wheels.
3. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
4. If removing wheels, loosen the lug nuts.
5. Lift one side of vehicle and support on jack stands (Figure 3-5, Page 3-6).
6. Lift other side of vehicle and support on jack stands.
7. Remove the wheels.
1025
Figure 3-5 Jack Stand Placement
USING A BOOSTER BATTERY (JUMP STARTING)
See General Warning on page 1-2.
WARNING
• Wear safety glasses or approved eye protection when servicing the vehicle. Wear a full face shield and
rubber gloves when working on or near batteries.
• When jumping from a booster battery, make the final connection the negative (-) cable.
• Do not jump start or charge a frozen or damaged battery. Unplug charger before connecting or
disconnecting cables to the battery. Never lean over battery while boosting, testing, or charging.
If it is necessary to use a booster battery to start the engine, BE CAREFUL!
1. Turn the key switch to the OFF position. Place the Forward/Reverse handle in the NEUTRAL position, engage
the park brake and chock the wheels.
2. Ensure the booster battery is 12-volt. See following NOTE.
NOTE: A starting battery is recommended but a deep cycle battery can be used if necessary.
3. Access battery by removing the seat.
4. Locate the vehicle battery on the passenger side of the vehicle.
Page 3-6 2009-2010 HUV 4214, HUV 4414, and HUV 4414X Maintenance and Service Manual
GENERAL INFORMATION