Front Fascia Installation - Husqvarna HUV 4214 2009 Maintenance And Service Manual

BODY AND TRIM
1054
Figure 4-3 Front Fascia Removal – pulling fascia forward
4. Grip fascia, lift slightly to disengage the front fascia hook and pull fascia forward slightly to expose the headlight
wiring (Figure 4-3, Page 4-5).
1053
Figure 4-4 Front Fascia Removal – disconnect headlights
5. Disconnect headlight wiring at connectors (Figure 4-4, Page 4-5).
6. Carefully remove front fascia from vehicle.

FRONT FASCIA INSTALLATION

1. Move front fascia in place and connect headlight wiring (Figure 4-4, Page 4-5).
2. Carefully insert molded-in lower front fascia retaining hook into receiving slot in the fascia mounting frame.
3. Secure the fascia to the fascia mounting frame using four bolts. Tighten the hardware to 22 in-lb (2.5 N·m).
4. Secure the front of the each fender to the lower corner of the fascia using two torx-head screws. Tighten screws
to 22 in-lb (2.5 N·m).
2009-2010 HUV 4214, HUV 4414, and HUV 4414X Maintenance and Service Manual
4
Front Body
Page 4-5