Accelerator Pedal Installation - Husqvarna HUV 4214 2009 Maintenance And Service Manual

ACCELERATOR AND BRAKE PEDAL GROUP
1195
Figure 5-7 Remove Bow-Tie Locking Pin and Washer
9. Remove rue pin and clevis pin securing master cylinder push rod to brake pedal (Figure 5-20, Page 5-8).
10. Remove hardware securing the pedal group assembly to chassis (Figure 5-8, Page 5-3) and (Figure 5-9,
Page 5-3).
1190
Figure 5-8 Accelerator Pedal Removal – pedal assembly
hardware
11. With pedal group loose, maneuver it to a position that will allow the accelerator pedal return spring to be detached
from the bracket. Loosen spring retaining nut if necessary.
12. Slide accelerator pedal out of pedal group bracket.

ACCELERATOR PEDAL INSTALLATION

1. Installation is reverse of removal procedure.
2. Check return spring height and adjust if necessary (Figure 5-10, Page 5-4).
3. Tighten pedal group hardware to 180 in-lb (20 N·m).
2009-2010 HUV 4214, HUV 4414, and HUV 4414X Maintenance and Service Manual
Accelerator Pedal Installation
1191
Figure 5-9 Accelerator Pedal Removal – pedal assembly
hardware
5
Page 5-3