Under Pedal Closeout Panel Installation; Under Seat Closeout Panels; Under Seat Closeout Panel Removal - Husqvarna HUV 4214 2009 Maintenance And Service Manual

BODY AND TRIM
2. Pull the closeout panel back and down passing it over the pedals.
3. Remove closeout panel from vehicle.
1179
Figure 4-21 Under Pedal Closeout Panel Removal

UNDER PEDAL CLOSEOUT PANEL INSTALLATION

1. Install under pedal closeout panel in the reverse order of removal.

UNDER SEAT CLOSEOUT PANELS

See General Warning on page 1-2.

UNDER SEAT CLOSEOUT PANEL REMOVAL

1. Raise the cargo bed and engage the cargo bed lock pin (1) located at the driver side cargo bed hinge (2).
(Figure 4-22, Page 4-14).
2. Remove seat bottom from vehicle.
3. Locate the center closeout panel. Flex closeout panel to disengage front lower lip that rests behind seat belt
anchors and rotate up and back towards rear of vehicle. Remove center closeout panel from vehicle(Figure
4-23, Page 4-14).
4. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
2009-2010 HUV 4214, HUV 4414, and HUV 4414X Maintenance and Service Manual
Under Seat Closeout Panels
4
Page 4-13