Under Seat Center Panel Installation; Rear Fender; Rear Fender Removal - Husqvarna HUV 4214 2009 Maintenance And Service Manual

BODY AND TRIM
1040
Figure 4-34 Under Seat Center Panel Removal

UNDER SEAT CENTER PANEL INSTALLATION

1. Install under seat center panel in the reverse order of removal. Tighten bolts to 22 in-lb (2.5 N·m).

REAR FENDER

See General Warning on page 1-2.

REAR FENDER REMOVAL

1. Raise the cargo bed and engage the cargo bed lock pin located at the driver side cargo bed hinge (Figure
4-36, Page 4-22).
2. Remove the four bolts that secure the fender to the underside of the cargo bed (Figure 4-37, Page 4-22).
2009-2010 HUV 4214, HUV 4414, and HUV 4414X Maintenance and Service Manual
1041
Figure 4-35 Under Seat Center Panel Removed From
Vehicle
4
Rear Fender
Page 4-21