DC link components
8.1 Braking Module
8.1.4.4
Installing the Braking Module in a Smart Line Module / Active Line Module / Motor
Module, frame size JX
Figure 8-11
Installing the Braking Module
The steps for the installation procedure are numbered in accordance with the diagram.
1. Insert the Braking Module.
2. Tighten the four retaining screws for the Braking Module.
3. Secure the connection clip to the DC link (DCPA/DCNA) with two screws (Braking Module
connection) and two nuts (DC-link connection).
Note
Pay attention to the tightening torques
The tightening torques specified in the table "Tightening torques for screw connections" must
be observed.
338
Installing the Braking Module in a Smart Line Module / Active Line Module / Motor
Module, frame size JX
Air-cooled chassis power units
Manual, 07/2019, 6SL3097-4AE00-0BP9