Brother KE-430F Service Manual page 24

4. FUNCTION SETTINGS
Initial values for each application
No. KE-430F-03
260
261
262
263
264
265
266
No. Setting range
OFF, 1 − 99
267
(stitches)
0 − 2
268
0 − 2
269
0 − 2
270
271 ON/OFF
272 ON/OFF
273 ON/OFF
14
KE-430F-05
-15 -15
45 50
45 45
45 45
0 25
35 35
35 0
Initial
Setting units
value
OFF
1
430F: 0
438F: 1
2
OFF
OFF
OFF
KE-430F-0K
-15
45
45
45
0
35
35
If the overall feed timing (setting No. 260) has been changed
from the default value, this specifies the effective number of
stitches.
OFF: No limit
1
1 to 99: When the specified number of stitches from the
sewing start is exceeded, the feed timing returns to
the standard timing.
Changes the overall feed timing reference.
0: [Feed start reference] Makes the timing uniform at the start
of feed.
1: [Needle up reference] Changes the timing at the start of
1
feed so that the feed moves half the feed width when the
needle bar is at its highest position.
2: [Feed end reference] Makes the timing uniform at the end
of feed.
Changes the feed timing reference for the first three stitches at
the sewing start.
0: [Feed start reference] Makes the timing uniform at the start
of feed.
1
1: [Needle up reference] Changes the timing at the start of
feed so that the feed moves half the feed width when the
needle bar is at its highest position.
2: [Feed end reference] Makes the timing uniform at the end
of feed.
Moving method to the sewing start point after the program is
changed
* However, operation for the "0" setting is always carried out
when No. 273 is set to ON.
2
0: Moves to sewing start position and then stops.
2: Home position detection is carried out, then moves to the
sewing start position and stops.
Work clamp/button clamp standby position
ON: For the 430F, the center of the sewing area is the standby
position (escape point).
-
For the 438F, the front is the standby position (escape
point).
OFF: The sewing start position becomes the standby position.
Reduced feed noise
ON: Enable (Operating speed is limited to 2500 sti/min.)
-
OFF: Disable
Start switch operation after program is changed
ON: Moves to sewing start position and starts (program No.
illuminates)
-
OFF: Only moves to sewing start position (program No.
flashes)
KE-430F, BE-438F
KE-430F-0F BE-438F
-15 10
45 -80
45 -50
45 -50
0
35 15
35 15
Setting details
0