Updating The Control Program Version - Brother KE-430F Service Manual

7. USING SD CARDS

7-13. Updating the control program version

1 Place the control program that you would like to update into the folder of the SD card as specified in "7-2. Structure of
a SD card folder".
With the power switch turned off, insert the SD card into the SD card slot.
2
(Refer to step 1 in "7-3. Preparation for reading and writing data".)
3
4
5
6
7
Turn off the power switch.
54
"WAIT" will appear in the menu
display and the value in the
tension display will increment
while the program version is
being updated.
2680B 2681B
KE-430F, BE-438F
While holding down the RESET, TEST and ▲ keys, turn
on the power switch.
The same "bro", "ther", "-F" (may vary depending on
specifications) and "430" ("438" as appear in the
PROGRAM No. display, menu display, section No.
display and tension display will appear. Keep holding
down the keys until you hear a beep.
2676B
"1.Mn"will appear in the PROGRAM No. display and
"*.*.**" (control program version stored on the SD card)
will appear in the menu display.
2678B
Press the or
updated.
Control program
Main
Motor
Panel
・ If there is no program to be updated which is stored on
the SD card, "----" will appear in the menu display.
2679B
Press the ENTER key.
・ The buzzer will sound and updating of the program
version will start.
・ When "End" appears in the menu display, updating is
complete.
・ To continue updating another program, return to step
5 and select the next program to be updated.
key to select the program to be
PROGRAM No.
display display
[1.Mn] [*.*.**]
[2.Mt] [*.**]
[3.PL] [*.**]
2677B
Menu
2414B