Brother KE-430F Service Manual page 36

4. FUNCTION SETTINGS
Item No. Item name
[ 5] [orP]
[ 6] [EnP]
[ 7] [dEG]
[ 8] [ UP]
[ 9] [voL]
[ 10] [PnL]
[ 11] [FtA]
[ 12] [FtS]
[ 13] [CL1]
[ 14] [CL2]
[ 15] [Stt]
26
Input status
Work clamp motor home position sensor position
Remove the side cover and raise the work clamp/button clamp
[ on] / [ oFF]
manually.
* ON when raised, OFF when lowered.
Work clamp motor encoder counter value
Remove the side cover and raise the work clamp/button clamp
[-999] − [ 999]
manually.
* Back = down, and forward = up.
* When the power is turned on, the position will be "0".
Upper shaft 360 rotation segment signal
[ 000] − [ 359]
Turn the pulley by hand.
* The forward direction (the direction of the arrow) = up.
Needle up signal
[ on] / [ oFF] Turn the pulley by hand.
* ON in the needle up region, OFF in any other region.
[ ***] Shows the input voltage.
Operation panel key input check
[*] / [ oFF]
The key name will be displayed while a key is pressed.
* ON display
[rESt] RESET key
[tESt] TEST key
[tHrE] THREAD/CLAMP key
[ tEn] TENSION key
[SELE] SELECT key
[UP-M] key
[dn-M] key
[UP-S] SECTION + key
[dn-S] SECTION - key
[UP-t] TENSION + key
[dn-t] TENSION - key
[ F1] Function key F1
[ F2] Function key F2
[ F3] Function key F3
[ F4] Function key F4
[ Ent] ENTER key
Foot switch analog value
Depress the foot switch.
0] − [ 255]
* When depressed forward, the value increases.
[
* Should normally display somewhere around 102 when at the
neutral position.
Foot switch signal
bAck: Depressed backward
[bAck] / [oFF] /
oFF：Neutral
[CLnp] / [Strt]
CLnP：1st step (Work clamp signal)
Strt：2nd step (Start signal)
Work clamp switch 1st step for 2-step foot switch
[ on] / [ oFF]
Depress the work clamp switch to the 1st step.
Work clamp switch 2nd step for 2-step foot switch
[ on] / [ oFF]
Depress the work clamp switch to the 2nd step.
Start switch for 2-step foot switch
[ on] / [ oFF]
Depress the start switch.
KE-430F, BE-438F
Check items and checking methods
Key name