Section 6 - Preventive / Corrective Maintenance
E-Compact Transmitters
STEP 5
STEP 6
STEP 7
Power Drawer MOD GV 40010 / 40033 (Medium Power)
To replace the fans, follow the steps below.:
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Manual Rev. 0.0 - June 2016
Disconnect the plug cables from the fan bus board (CIP 8861).
Figure 10 - Fan connection
Replace the three fans.
Reinstall the fans by reversing the order of the above steps
Remove the screws from the front panel of the drawer.
Remove the front panel of the drawer.
Remove air filter screws.
Clean with compressed air, wash with detergent / water, or replace if necessary.
Remove the screws from each fan.
Disconnect the plug cables from the fan bus board (CIM 30260).
PLUG connector (CIM 30260)
Conector PLUG (CIM 3260)
Figure 11 - Fan connection -
MOD GV 40010 / 40033
Cabo
Plug
c able
plug
6-11