Section 3 - Installation (ATSC EC701HP Transmitter)
B- Grounding
Insert the ground cable through the hole and connect it to the screw at the bottom of the
rack.
Before energizing the transmitter, ensure that the localized circuit breaker on the right
rear side of the transmitter rack is off.
C- Rigid line / Filter / Antenna
Connect the rigid lines as required to interconnect the equipment to the filter and the filter to
the antenna.
Manual Rev. 0.0 - March 2018
GROUNDING SCREW
Grounding screws - Bottom of
Figure 3-26
the rack
ATTENTION
GROUNDING SCREW
3-27