On--Board Battery Charger - Toro Workman GTX Electric & Lithium Service Manual

On- -board Battery Charger
The Workman GTX Electric on--board battery charger is
1
attached to the right side of the vehicle under the opera-
tor seat.
Power input to the charger is provided at the charging
receptacle by an AC power supply cord.
If the plug does not fit into the wall receptacle, other
grounded plug types are available; contact an author-
ized Toro distributor. Do not change the charger or the
power--supply--cord plug in any way.
The battery pack charging operation is fully automated.
2
While connected to an AC power supply, charger activity
can be monitored at the display on the dash of the vehi-
cle. To view the current charging status, turn the key
switch to the ON position. When you are done viewing
the charging status, turn the key switch to the OFF posi-
tion to optimize the charging process.
Figure 46
1. Battery charger 2. Charging receptacle
NOTE: The display shows messages during the course
of charging. Most are routine.
The on--board battery charger is connected to the
vehicle CAN bus. If there is a fault exist with the battery
charger, an error message will appear on the display 1
digit at a time, starting with the letter E or F (e.g.,
E--0--1--1).
NOTE: Refer to On--board Battery Charger in the Ser-
vice and Repairs section of this chapter for battery
charger removal and installation information.
To correct an error, refer to Troubleshooting. If none of
these solutions correct the issue, contact an authorized
Toro distributor.
Figure 47
Workman GTX Electric Lithium Page 3B - - 43 Electrical System