Toro Workman GTX Electric & Lithium Service Manual page 193

Removal (Fig. 41)
1. Park vehicle on a level surface, turn key switch OFF,
apply parking brake and remove key from the key
switch.
2. Remove front fenders, hood or front bumper using
Figure 41 as a guide.
Workman GTX Electric
Installation (Fig. 41)
NOTE: Do not fully tighten fasteners securing body
components until all fasteners are in place.
1. Install removed body components using Figure 41
as a guide. During assembly, use fastener torque speci-
fications that are identified in Figure 41.
Page 5 - - 45 Chassis