Toro Workman GTX Electric & Lithium Service Manual page 189

Disassembly (Fig. 37)
1. Park vehicle on a level surface, turn key switch OFF,
apply parking brake and remove key from the key
switch.
2. Remove seat base assembly with attached seats
from vehicle.
3. If left hand seat base side is to be removed from vehi-
cle (Fig. 38):
A. Remove onboard battery charger from vehicle
(see Onboard Battery Charger in the Service and
Repairs section of Chapter 3 -- Electrical System).
B. Remove four (4) screws that secure seat base
side to charger bracket (Fig. 38).
C. Support left hand seat base side and remove four
(4) screws that secure seat base side to supports il-
lustrated in Figure 37.
D. Remove left hand seat base side from vehicle.
4. Remove remaining seat base panels and supports
from vehicle as needed using Figure 37 as a guide.
5. If needed, remove seats from seat base (Fig. 39).
Assembly (Fig. 37)
1. Secure seats to seat base if they were removed (Fig.
39). Torque cap screws from 90 to 110 in- -lb (10.2 to
12.4 N- -m).
2. Install all removed seat base panels and supports to
vehicle using Figures 37 and 38 as guides. When secur-
ing seat base supports to vehicle, use torque values
identified in Figures 37 and 38.
3. If onboard battery charger was removed from vehi-
cle, install charger (see Onboard Battery Charger in the
Service and Repairs section of Chapter 3 -- Electrical
System).
4. Install seat base assembly with attached seats to ve-
hicle.
Workman GTX Electric
18 to 22 in- -lb
(2.1 to 2.4 N- -m)
2
6
3
FRONT
1. Battery charger
2. Screw (4 used)
3. Flange nut (4 used)
1
5
6
1. Seat base
2. Seat (2 used)
3. Cap screw (8 used)
Page 5 - - 41
1
4
6
18 to 22 in- -lb
(2.1 to 2.4 N- -m)
Figure 38
4. Charger bracket
5. LH seat base side
6. Screw (4 used)
2
90 to 110 in- -lb
(10.2 to 12.4 N- -m)
3
4
Figure 39
4. Flat washer (8 used)
5. Retainer (2 used)
6. Screw (4 used)
5
Chassis