Reverse Audio Alarm (If Equipped) - Toro Workman GTX Electric & Lithium Service Manual

Reverse Audio Alarm (If Equipped)

The reverse alarm sounds when the direction switch
(forward/reverse) is placed in the reverse position. The
alarm is located under the seat assembly attached to the
rear frame panel below the supervision speed limit
switch (Fig. 51).
Testing
IMPORTANT: Make sure to observe polarity on the
alarm terminals when testing. Damage to the alarm
may result from an improper connection.
IMPORTANT: The audio alarm is a 12 volt DC com-
ponent. Do not test the alarm using jumper wires
from the vehicle battery pack (48 VDC).
1. Park vehicle on a level surface, turn key switch to
OFF, engage the parking brake and remove key from
the key switch.
2. Remove seat assembly from vehicle to access re-
verse alarm. Locate alarm on rear frame panel.
3. Disconnect wire harness connectors from alarm
(Fig. 51).
4. Using jumper wires, correctly connect 12VDC
source to the alarm terminals noting polarity shown in
Figure 52.
5. Alarm should sound as long as voltage is applied to
alarm terminals. Remove voltage source from the
alarm.
6. Replace alarm if testing determines that it is faulty.
7. Connect wire harness connectors to alarm. Install
seat assembly on vehicle.
Electrical System
1. Fuse block
1
1. Alarm (top view)
2. Alarm (bottom view)
Page 3B - - 46
1
Figure 51
2. Reverse audio alarm
2
4
Figure 52
3. Positive (+) terminal
4. Negative (- -) terminal
Workman GTX Electric Lithium
3