Light Switch - Toro Workman GTX Electric & Lithium Service Manual

Light Switch

The light switch allows the headlights to be turned ON
and OFF. This rocker switch is located on the dash panel
(Fig. 17).
NOTE: The Workman GTX Electric headlight circuit is
a 12 VDC circuit.
Testing
1. Park vehicle on a level surface, turn key switch to
OFF, engage the parking brake and remove key from
the key switch.
2. Raise hood to allow access to wire harness connec-
tions for switches mounted in dash.
3. Disconnect wire harness connector from the light
switch.
4. With the use of a multimeter (ohms setting), the
switch functions may be tested to determine whether
continuity exists between the various terminals for each
light switch position. The light switch terminals are
marked as shown in Figure 18. The circuitry of this
switch is shown in the chart below. Verify continuity be-
tween switch terminals.
SWITCH NORMAL
POSITION CIRCUITS
ON
OFF
5. Replace light switch if testing determines that the
switch is faulty.
6. If light switch tests correctly and circuit problem still
exists, check fuse, headlights and wire harness for pos-
sible problems (see electrical schematic and wire har-
ness drawing in Chapter 6 -- Electrical Drawings).
7. After light switch testing is complete, connect wire
harness connector to the light switch. Lower and secure
front hood.
Workman GTX Electric
OTHER
CIRCUITS
2 + 3 5 + 6
1 + 2 4 + 5
Page 3A - - 15
2
1
Figure 17
1. Dash panel
Figure 18
2. Light switch
Electrical System