Huawei ECC800 User Manual page 148

ECC800 Data Center Controller
User Manual
Step 3 Click Confirm after video information is entered.
Step 4 In the Video information list, click a link address under Link to go to the camera WebUI as
instructed.
Step 5 For details about how to commission IP cameras and set parameters for them, see the
document delivered or click
1.
2.
3.
Set coding protocol to H.264.
Issue 07 (2020-03-16)
Preview the site situation in real time and check the camera coverage through videos.
Adjust the lens if necessary.
(Optional) If you use the SD card when no VCM500 is configured, perform
commissioning by following the instructions in
(SD Card Configured).
Set camera stream type, primary stream, and secondary stream 1 parameters.
Figure 5-20 Setting primary stream parameters
Copyright © Huawei Technologies Co., Ltd.
here to download the document.
5 Power-On Commissioning
5.7.4 Commissioning IPC6325 Camera
139