Huawei ECC800 User Manual page 28

ECC800 Data Center Controller
User Manual
Button
Name
Default
Communications Ports
The ECC800 provides the following communications ports.
RJ45 port.
Figure 3-4 RJ45 port pins
Issue 07 (2020-03-16)
Function Operation Description
Description
automatically exits the pairing mode
after 30 minutes without pressing
the button.
Press and hold down the button for
more than 6s to clear network
parameters.
WiFi pairing In non-WiFi pairing mode, press the
button button for less than 1.2s to enter the
WiFi pairing mode.
NOTE
This function is
supported only
in a scenario
where the WiFi
converter is
configured.
IP address reset Hold down the button for at least 3s.
Then the IP addresses for the
ECC800 WAN_1 and WAN_2
ports will restore to the default
addresses.
Copyright © Huawei Technologies Co., Ltd.
3 Device Description
Indicator Status
The RF_Z indicator
is on.
 When the system
enters the pairing
mode, the RUN
indicator is
steady on.
 After pairing
succeeds, the
RUN indicator
blinks just as
before WiFi
pairing.
 If pairing does
not succeed in 3
minutes, the RUN
indicator blinks
just as before
WiFi pairing.
None
Figure 3-4 shows the pins of the
19