Commissioning An Access Control Device And A Cabinet Electronic Lock - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Table 5-35 Function commissioning
Check Method
Check the running information
about the T/H sensor on the
WebUI.
Set T/H sensor alarm thresholds.
----End
5.5.7 Commissioning an Access Control Device and a Cabinet
Electronic Lock
If an access control device and cabinet electric lock are installed, perform the following steps
to configure it.
Prerequisites


Context
Add or modify user on the Access User Management page, add or modify user rights on the
Access Right Management page. The added or modified user accounts and rights are saved
only in the ECC800 main control module. The modified rights take effect in the access control
device only after you click Synchronize Permission on the Access Right Management
page.
Procedure
Step 1 Set access user management.
Issue 07 (2020-03-16)
When the fingerprint reader is connected to the ECC800 for the first time, the
permissions need to be synchronized.
If multiple access control devices and cabinet electronic locks are connected,
commission one access control device and cabinet electronic lock first, and then
commission the other access control devices and cabinet electronic locks in the same
way.
Copyright © Huawei Technologies Co., Ltd.
Normal Connection Status
Choose Monitoring > Aisle > T/H Sensor Group >
T/H Sensor n > Running Info, and check the current
T/H information of the cabinet.
Choose Monitoring > Aisle > T/H Sensor Group >
T/H Sensor n > Running Parameters, and set High
temperature alarm threshold, Low temperature
alarm threshold, High humidity alarm threshold,
and Low humidity alarm threshold as required.
NOTE
The default values of High temperature alarm threshold,
Low temperature alarm threshold, High humidity alarm
threshold, and Low humidity alarm threshold are 30.0° C,
5.0° C, 85.0% RH, and 15.0% RH, respectively.
5 Power-On Commissioning
126