NEC Express 5800 Series Maintenance Manual page 134

Chapter 3 Appendix
(1) Error messages
Error Message
System variable is
8000
corrupted.
8002 Check date and time
settings
8006 System configuration data
cleared by Jumper.
8007 SETUP Menu Password
cleared by Jumper.
8020 BIOS update error.
8021 Recovery jumper is set,
but recovery images is not
found.
8800 DXE_NB_ERROR
8801 DXE_NO_CON_IN
8802 DXE_NO_CON_OUT
9000 Unsupported CPU
detected
9E80 Forced to use CPU with
error.
AB00 Memory not detected
AE01 DIMM1 has been disabled. A memory error occurred.
AE02 DIMM2 has been disabled. A memory error occurred.
DIMM3 has been disabled. A memory error occurred.
AE03
AE04 DIMM4 has been disabled. A memory error occurred.
AE81 DIMM1 with error is
enabled.
AE82 DIMM2 with error is
enabled.
B000 Expansion ROM not
initialized
B001 Expansion ROM not
initialized - PCI Slot 1
(Express5800/T110f-S,
T110f-E)
B002 Expansion ROM not
initialized - PCI Slot 2
(Express5800/T110f-S,
T110f-E)
B003 Expansion ROM not
initialized - PCI Slot 3
(Express5800/T110f-S,
T110f-E)
134
Description
BIOS settings are invalid.
The real-time clock is incorrect.
The setup utility settings were
cleared by the jumper.
The setup utility password was
cleared by the jumper.
BIOS update failed.
The recovery jumper is set but
the BIOS recovery failed.
An error was detected during
initialization of the chipset
An error was detected during
initialization of the console.
An unsupported CPU was
detected.
A CPU error occurred.
No valid memory is installed.
DIMM1 has been disabled.
DIMM2 has been disabled.
DIMM3 has been disabled.
DIMM4 has been disabled.
An error in DIMM1 occurred.
The DIMM1 was forcibly enables
because all memory is currently
disabled.
An error in DIMM2 occurred.
The DIMM2 was forcibly enables
because all memory is currently
disabled.
There is no memory for
expanding option ROM.
Option ROM expansion in PCI
slot 1 failed.
Option ROM expansion in PCI
slot 2 failed.
Option ROM expansion in PCI
slot 3 failed.
Express5800/T110f-S, R110f-1E, T110f-E Maintenance Guide
1. POST Error Message
Action
Run the setup utility, and then
execute Load Setup Defaults and
specify the necessary settings. If the
same error continues to occur,
contact your sales representative.
Run the setup utility, and then specify
the correct date and time. If the same
error continues to occur, contact your
sales representative.
See Chapter 1 (7. Resetting and
Clearing the Server).
Try BIOS update again. If it fails
again, contact your sales
representative.
Contact your sales representative.
Check if the memory modules are
properly installed. If the same error is
displayed consecutively, contact your
sales representative.
Contact your sales representative.
If the PCI board does not connect to a
bootable device, disable the Option
ROM Scan for that board.
(1/4)