Panasonic AV-HS6000 Series Operation Manual page 54

f The bus tallies on the right of the PGM/A bus crosspoint buttons and the PST/B bus crosspoint buttons indicate the output status of the program
bus.
Lighting color
Red
Amber
Off
r Setting the transition time
1
Select the <ME1>/<ME2> button → [BKGD] → [Transition] tab.
2
Set [Time] in the [Transition] column.
f Set the transition time.
@ NOTE
t The units used for time display of the unit can be set to either in seconds/frame or in frames. (page 136)
r Setting the start and end points of a transition
1
Select the <ME1>/<ME2> button → [BKGD] → [Transition] tab.
2
Set [Start Point] and [End Point] in the [Transition] column.
[Start Point]
[End Point]
f While the <PATT LIMIT> is lighting up, the settings of [Start Point] and [End Point] are disabled.
r <NAM> button setting
Sets the operation of the background transition when both the <MIX> button and the <NAM> button are set ON.
1
Select the <ME1>/<ME2> button → [BKGD] → [Transition] tab.
2
Set [NAM]/[CMIX] in the [Trans Type] column.
[NAM]
[CMIX]
3
Adjust the color.
[Hue], [Sat], [Lum] or [Color Palette] is set in the [CMIX Color] column.
Chapter 5 Basic Operations — Background transition
Lights when the relevant bus is included in the on-air output.
Lights when the relevant bus is not included in the on-air output but included in the program output.
Lights when the relevant bus is included in neither the on-air output nor the program output.
Sets the start point for the background transition.
The background transition will start after the start point of the manual transition or the auto transition when a value
larger than 0 is set for [Start Point]. At this time, the lamp for start point of the fader lever will blink in the transition status
display.
Sets the end point for background transition.
The background transition will complete before the end point of the manual transition or the auto transition when a value
larger than 0 is set for [End Point]. At this time, the lamp for end point of the fader lever will blink in the transition status
display.
Switches the images in the A bus/B bus with non-additive mixing.
It will be high luminance with the A bus at 100% and the B bus at 100% when the fader lever is positioned midway.
It will perform the MIX mixing (color mix mixing) set in the [CMIX Color] column at the midway of the images of A bus/B
bus.
Description
– 54 –