Bosch Video Management System
Name:
Type the name of the new virtual inputs. A consecutive number is appended.
Add
Click to add the new virtual inputs.
17.18
SNMP page
Main window >
Allows you to add or configure an SNMP measurement for maintaining the network quality.
17.18.1
Add SNMP dialog box
Main window >
Allows you to add a network monitoring system to your Bosch Video Management System.
Name:
Type a name for the network monitoring device.
17.18.2
SNMP Trap Receiver page
Main window >
Allows you to select devices for monitoring and to select SNMP trap OIDs that trigger an event
for the selected device when they are received.
NOTICE!
You must enter the IP address of the Bosch Video Management System Central Server as the
trap receiver in your devices that you want to monitor.
SNMP Trap Sending Devices:
Allows you to enter a range of IP addresses of the monitored network devices. To monitor a
single device enter the corresponding IP address in the Range From cell.
Be careful when changing these addresses. Entering a wrong address stops network
monitoring of this device.
SNMP Trap Filter Rules:
Allows you to enter OIDs and corresponding values. You can use wildcards as * and ? to
enhance the filter range. If you enter OIDs and values in more than one row, these filter rules
must match simultaneously to trigger an event. In both columns, you can enter a regular
expression in {}. If there are characters outside the brackets, the regular expression is not
evaluated.
Show Trap Logger Tool
Click to display the SNMP Trap Logger dialog box for tracing SNMP trap OIDs.
17.18.3
SNMP Trap Logger dialog box
Main window >
Receiver > Click Show Trap Logger Tool
Bosch Sicherheitssysteme GmbH
Devices > Expand
>
Devices > Expand
> Right-click
Devices > Expand
> Expand
Devices > Expand
> Expand
Configuration Manual
Devices page | en 103
> Add SNMP command
> Select a generic SNMP Trap
Configuration Client | V3 | 2010.07