Fujitsu ETERNUS LT260 User Manual page 29

Chapter 3 Setting the Operating System
3.1 Solaris OS
• Example
#
# Copyright 2004 Sun Microsystems, Inc.
# Use is subject to license terms.
#
#
#pragma ident
#
name="st" class="scsi" target=0 lun=0;
name="st" class="scsi" target=1 lun=0;
name="st" class="scsi" target=2 lun=0;
name="st" class="scsi" target=3 lun=0;
name="st" class="scsi" target=4 lun=0;
name="st" class="scsi" target=5 lun=0;
name="st" class="scsi" target=6 lun=0;
#
# In case there are wide tape drives, one can use these targets
#
#name="st" class="scsi" target=8 lun=0;
#name="st" class="scsi" target=9 lun=0;
#name="st" class="scsi" target=10 lun=0;
#name="st" class="scsi" target=11 lun=0;
#name="st" class="scsi" target=12 lun=0;
#name="st" class="scsi" target=13 lun=0;
#name="st" class="scsi" target=14 lun=0;
#name="st" class="scsi" target=15 lun=0;
# This line adds support for Fibre Channel Tapes
name="st" parent="fp" target=0;
- FC-AL connection
For "target=", specify the Loop-ID that is set in the LT260.
- Fabric connection (for SE0X7F11X or SE0X7F12X only)
For "target=", specify the target ID of the "fcp-bind-target" parameter that is described in the setting file
of the HBA device driver (/kernel/drv/fjpfca.conf).
The setting file does not need to be edited for SE0X7F21X, SE0X7F22X, SE0X7F31X, and SE0X7F32X.
(2) Restart the server.
Reconfigure and restart the server to make the server recognize the registered device. Execute the
following command.
# touch /reconfigure
# /usr/sbin/shutdown -y -g0 -i6
(3) Check the device files.
Check the device files after the server reboots.
# ls /dev/rmt
FUJITSU Storage ETERNUS LT260 Tape Library User's Guide -Server Connection-
"@(#)st.conf 1.34
29
Copyright 2019 FUJITSU LIMITED
All rights reserved.
04/06/24 SMI"
P3AM-8812-07ENZ0